Monday, November 1, 2010

How to get perfect silicone caulking joints

When I was first given the task of caulking a tub I struggled mightily and it was a disaster. Nobody told me I only had a minute to work with the silicone caulk before it skinned over and became impossible to smooth out without tearing the surface. When silicone caulk is exposed to air it skins over almost immediately so you have a minute or less to tool it and make it perfect. Here is the system I devised to get it right every time.


-Make sure the tile and tub surface is cleaned and all the soap scum is removed. Not much sticks to soap scum. You can use a number of soap scum cleaners for this.
-Use a single edge razor blade in a holder to scrape off any old caulking and residue. I avoid metal putty knives because they leave marks on tile and porcelain tub finishes.
-Make sure the joint is cleaned of any loose debris
-Get a roll of 1-1/2" wide blue painter's tape and apply it to the walls approx. 1/16" - 1/8" on both sides of the inside corner. It will leave a tiny strip of tile showing between the blue tape. Press the tape into the tile so it sticks well. Don't press the whole width of the tape tight, just the inside edge so it peels off easier later.
-Do this tape thing for all the vertical inside corners.
-Cut the tip off the silicone tube so the hole is about 1/8". Start squeezing the caulking into the slit between the painter's tape. You don't need much because you will be removing most of it with your finger next so don't overdo it. ***Only caulk one joint at a time***
-Soak a rag in denatured alcohol, rub it all over the tip of your index finger and run your finger down over the caulking making it smooth. The alcohol keeps the caulking from sticking to your fingers. If you are in a pinch you can spit on your finger and it'll do the same thing. The alcohol is good to have around as it'll clean up wet silicone like nothing else in case you get it all over the place.
-Put the caulking gun down and immediately peel off the blue tape. Sometimes if you don't press hard enough the tape will leave a slight ridge when it's peeled off. Don't worry, it'll still keep water out but sometimes I just wet my finger and give it a gentle run down the joint just to smooth it out. Don't put much pressure on it and do it right away or it''ll drag the surface since it skins over so quickly. This is why you only do one joint at a time.
-The caulk-covered tape is a sticky mess so you should have a box or trash can handy to dispose of it right away.
-Once all the vertical joints have skinned over you can move to the horizontal joints.
Just remember to move quickly. Tool it once with your finger and leave it alone. I have caulked hundreds of feet of tub walls so let me know if you have any questions. Good luck!






36 comments:

  1. This comment has been removed by a blog administrator.

    ReplyDelete
  2. This comment has been removed by a blog administrator.

    ReplyDelete
  3. This comment has been removed by a blog administrator.

    ReplyDelete
  4. This comment has been removed by a blog administrator.

    ReplyDelete
  5. This comment has been removed by a blog administrator.

    ReplyDelete
  6. This comment has been removed by a blog administrator.

    ReplyDelete
  7. This comment has been removed by a blog administrator.

    ReplyDelete
  8. This comment has been removed by a blog administrator.

    ReplyDelete
  9. This comment has been removed by a blog administrator.

    ReplyDelete
  10. This comment has been removed by a blog administrator.

    ReplyDelete
  11. God bless people like you. Praying that through this post, you will inspire more people.

    ReplyDelete
  12. Hello,
    Great post about kitchen improvement.
    Thanks! for sharing.

    ReplyDelete
  13. I have seen this way of caulking before. I can't believe I hadn't thought of it before. I am in the process of figuring out remodeling plans for my master bath so this will definitely come in handy when we do. They is nothing worse than getting caulk everywhere.

    Alena | http://www.allevaconstruction.com

    ReplyDelete
  14. I have always struggled with laying a perfect caulking job. It seems easy and I think I'm doing good but when it's dried, it's bad. I'm getting ready to do a home remodeling job, hopefully I can learn it better!

    Will Jenkins | http://www.mbabuildinggroup.com

    ReplyDelete
  15. My husband and I bought an old home that we want to fix up and sell. It has taken us a long time, but I think we are finally ready to do some more renovations. I want to work on the bathroom next and since my husband and I are doing most of the work we really needed the information in the blog. I hope that everything ends up going smoothly.
    Mia | http://www.apmdesignandconstruction.com.au/blue-mountains-builder-additions.php

    ReplyDelete
  16. I wish I was better with caulk! We just remodeled our kitchen and my seal on the sink was horrible! I think I am going to need to remove it and re-caulk it. I'll try to follow your advise this time aroun d! http://www.fredericksburgvahomebuilders.com/remodeling.html

    ReplyDelete
  17. This is some very helpful information. I have been doing some remodeling in my home, and I have had to use a lot of caulk. The next thing that I need to remodel is my shower. I am going to hire a professional to do this remodel because I don't want to mess it up trying to do it myself. http://www.jbcontractorsak.com/services

    ReplyDelete
  18. Thanks for sharing information about Home Remodeling. http://www.krozakremodeling.com/

    ReplyDelete
  19. I am truly inspired from your write-up and sharing this too with my friends and colleagues. Absolute Draining & Plumbing

    ReplyDelete
  20. This written piece gives fastidious understanding yet. port st lucie wind mitigation

    ReplyDelete
  21. The superb highly informative blog I’m about to share this with all my contacts. Rose Mount Kitchens

    ReplyDelete
  22. Hmm!! This blog is really cool, I’m so lucky that I have reached here and got this awesome information. construction

    ReplyDelete
  23. I even have been getting a lot of helpful and informative material in your web site. Envirotec General Contracting Ltd

    ReplyDelete
  24. I hope you will share such type of impressive contents again with us so that we can utilize it and get more advantage.

    flood removal port st lucie

    ReplyDelete
  25. These are the great blogs; I assure you that I really enjoyed a lot in reading.
    Nicholas Mancuso

    ReplyDelete
  26. Just saying thanks wouldn’t just be enough, for the fantastic fluency in your writing.

    Low Rate Carmichael ca

    ReplyDelete
  27. Nice blog and so informative thank you for sharing us.

    ReplyDelete
  28. Nice blog shared here. If you are looking for steel fibres for concrete then you can contact Precision Drawell. Thanks for sharing.

    ReplyDelete
  29. Remarkable blog! I have no words to praise, it has really allured me. Uk Oak Doors

    ReplyDelete
  30. Thank you for posting. Silicone caulk is very useful for sealing bathtubs and other fixtures. It can help stop water and moisture from seeping into joints, but it can be a challenge to apply smoothly and achieve a good, even finish.

    ReplyDelete
  31. Admiring the time and effort you put into your blog and detailed information you offer!..
    Certified Precision Roofing

    ReplyDelete
  32. Your blog is very informative, You explained very well. Thanks for sharing useful information with us.
    Home Remodeling Houston

    ReplyDelete
  33. ArmorThane develops, manufactures and distributes top-quality protective coatings and designs and engineers commercial application equipment. A multinational network of dealers spray coatings on everything from bed liners to secondary spill containment.For more information in regards to visit our website.Thank you! bedliner

    ReplyDelete